Indoor Walls

We were really interested in the performance of various rounds fired in a “standard” home setting. Frequently you hear or read about the debate about how far a round would fly around through a house (assuming it doesn’t impact with a person, furniture, etc). You have to worry about the penetration of various rounds when you have family and neighbors to worry about. Of course, here at stoppingpower.info this suggest that we had to build some walls and shoot them and display their performance.

Here’s the animation of the setup:

Walls Setup

Given that it gets expensive to build a setup to test, we built several small tests setups to use during this experiment.
* The front “wall” was framed with standard 2×4 studs, and then faced with 1/2″ drywall on both sides. The front wall was a 2′x2′ panel (we figured that all strikes would hit within this and save some money on our end).
* The back “wall” was framed with 2x4s with a stud in the center of the panel. 1/2″ drywall was applied to the front, while 3/4″ OSB (a chipboard used for exterior wall facing) was applied to the back wall. The back wall was a 4′x4′ panel, because we were concerned about getting all of the pattern, especially on the shotgun strikes.

Basically, think of it as shooting from inside, passing through one interior wall, and then hitting a wall that’s on the outside of the house.

Shooter position

We placed the shooter approximately seven yards away from the front wall of our room. I’d argue that this is a decent range to think about inside a house. If you want to talk about closer ranges, I’d suggest our results will be on par with what you are expecting. If you want to talk about farther distances, then you just have a bigger house than I do.

[[Image:stoppingpower-drywall-front.png]]

Room setup

To approximate a room, we used a room that was 12 ft wide (it doesn’t really matter) by 10 ft deep (this does matter). Again, there’s all types of room dimensions you’ll run across, but at least in the houses I’ve been in, this would be about average.

[[Image:stoppingpower-drywall-front2.png]]

Overhead room setup

This view shows the overall setup, and the camera positioning for each of the shots.

[[Image:stoppingpower-drywall-topdown-view.png]]

Actual Setup

Finally, we have a picture of the actual setup at the range.

[[Image:IndoorWalls-Actual-Setup.jpg]]

Disassembly of a Front Wall